IS-707 AT Commands (CDMA)
80-VG756-1 G 51 Qualcomm Confidential and Proprietary
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
Table 3-13 IS-707.3 Table 7.4.1-4. Cellular AT Commands for Packet Data Services 1
Command Description
Implementation
status
Explanation
+CTA=<value>
Set/read/test U
m
packet data inactivity timer;
values are;
0 – Traffic channel not released during
inactivity periods
1 to 255 – Release the traffic channel after
<value> 1-sec intervals have elapsed since
last sending or receiving RLP data frames
on the U
m
interface
Default value is 20.
All
Relevant
only for
packet
service
operation
+CPS=<value>*
Select the service option to be used for
packet data service; values shall be as
specified in TSB58
Not implemented
+CPSR=<value>*
Enable/disable packet call state reporting;
values are:
0 – Disable call state reporting
1 – Enable call state reporting
Not implemented
Call state
reporting not
supported
+CPTC=<value>*
Control traffic channel state without affecting
the IWF Link Layer connection; values are:
0 – Release traffic channel
1 – Originate traffic channel
Not implemented
+CPER=<value>*
Enable/disable packet call event reporting;
values are:
0 – Disable call event reporting
1 – Enable call event reporting
Not implemented
Packet call
event
reporting not
supported
3.2 Proprietary AT command set (CDMA) 2
This section provides the details for the Qualcomm-proprietary AT command set implementation 3
for DMSS software. The definition and purpose of each proprietary AT command implemented 4
by Qualcomm is described in Table 3-14. 5
Table 3-14 Vendor-specific AT commands 6
Command Description Operation
$QCQNC
Enable/disable Quick
Net Connect (QNC)
Values are:
0 – Disable QNC capability; this means that packet
originations will use the packet data service option
number
1 – Enable QNC capability; this means that packet
originations will use the async data service option
number
$QCMTOM*
Originate mobile-to-
mobile packet data call
using Qualcomm
proprietary service
option number
Complete command is AT$QCMTOM = <number>, where
<number> is the phone number to dial. This command will
originate a mobile-to-mobile packet data call using the
Qualcomm-proprietary service option number 0x8003.
This is a Rate Set 1 call.
Released - Internal Use Only
Released - Internal Use Only
(261 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern