IS-707 AT Commands (CDMA)
80-VG756-1 G 54 Qualcomm Confidential and Proprietary
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
Command Description Operation
$QCMIP
Enable/disable Mobile
IP
Values are:
0 – Mobile IP disabled, Simple IP only
1 – Mobile IP preferred
In the initial MIP registration, if the network does not
support Mobile IP, then the mobile automatically reverts
to Simple IP (force a PPP renegotiation by sending an
LCP C-Req).
However, if a Mobile IP session is registered, and the
mobile enters a network that does not support Mobile
IP, the mobile will drop the session and inform the
upper layers of the failure (e.g., by dropping DCD to a
laptop).
2 – Mobile IP only
The mobile will make data calls only when Mobile IP is
supported in the network. During a MIP session, if the
mobile hands off to a network that does not support
MIP, then the mobile will drop the session and inform
the upper layers of the failure (e.g., by dropping DCD to
a laptop).
This value is stored in NV. The default value is 0.
Note: When the AT$QCMIP value is changed to 1 or 2,
this modifies the value of AT+CRM to 2. AT+CRM with a
value of 2 enables network model operation. Changing
the value to 0 will reset the AT+CRM to its original value.
Note: This change is not supported by DMSS 5105
Release 1.0 Commercial.
Note: When the AT$QCMIP value is changed to 1 or 2,
this modifies the value of AT$QCMDR to 3.
AT$QCMDR=3 means that the mobile tries SO 33 when it
is in a cdma2000 network that advertises P_REV 6 or
higher. When AT$QCMIP >0 and an attempt is made to
set AT$QCMDR to less than 3, the mobile will return
ERROR.
Note: When the AT$QCMIP value is set to 1 or 2, this
changes the value of AT$QCPKND to 0. This means that
the mobile must see a dial string (such as ATDT#777) on
the serial interface before it will originate packet data
calls. When AT$QCMIP >0 and an attempt is made to set
AT$QCPKND to 1, the mobile returns ERROR.
Note: This AT command is for test purposes only and
should not be changed by the mobile phone user.
$QCMIPEP
Enable/disable currently
active profile
Values are:
0 – Disables the currently active profile (profile is
unavailable until it is reenabled
1 – Enables the currently active profile
$QCMIPGETP
Return all information
corresponding to the
specified profile number
Returns are:
If no profile number is entered, all information
corresponding to the currently active profile is returned.
If there is no profile associated with the specified
number, an error is returned.
$QCMIPMASPI
Set MN-AAA SPIs for
the currently active
profile
Two arguments – SPI value and one of the following:
0 – Do not commit to NV
1 – Commit to NV
Note: If the value provisioned is not committed to NV, the
temporary values will be deleted at the end of the
following call or if $QCMIPP is called.
Released - Internal Use Only
Released - Internal Use Only
(261 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern